Konfigurasi Link Agregation LACP di Fortinet

Dalam fortigate ada 3 mode LACP yang bisa kita gunakan diantaranya :
  • Active: actively use LACP to negotiate 802.3ad aggregation.
  • Passive: passively use LACP to negotiate 802.3ad aggregation.
  • Static: use static aggregation, do not send and ignore any LACP messages (all ports in the LAG will send traffic).

 

berikut contoh configurasi LACP pada Fortigate dalam menu CLI

config system interface
edit “lacp_ports”
set vdom “root”
set type aggregate
set member “port_member” “port_member”
set description ‘nama_deskripsi’
set lacp-mode active
set lacp-ha-slave enable
set lacp-speed slow
set algorithm L4
next
end

 

berikut perintah di CLI untuk melakukan pengecekan pada status LACP

LAB4# diag netlink aggregate name nama_link_agregate_anda

 

LACP flags: (A|P)(S|F)(A|I)(I|O)(E|D)(E|D)
(A|P) – LACP mode is Active or Passive
(S|F) – LACP speed is Slow or Fast
(A|I) – Aggregatable or Individual
(I|O) – Port In sync or Out of sync
(E|D) – Frame collection is Enabled or Disabled
(E|D) – Frame distribution is Enabled or Disabled

status: up
distribution algorithm: L4
LACP mode: active
LACP speed: slow
LACP HA: enable
aggregator ID: 1
ports: 2
actor key: 17
actor MAC address: 00:09:0f:68:35:94
partner key: 17
partner MAC address: 00:09:0f:68:37:d8

slave: port7
status: up
link failure count: 3
permanent MAC addr: 00:09:0f:68:35:94
actor state: ASAIEE
partner state: ASAIEE
aggregator ID: 1

slave: port8
status: up
link failure count: 2
permanent MAC addr: 00:09:0f:68:35:95
actor state: ASAIEE
partner state: ASAIEE
aggregator ID: 1

terima kasih

 

Leave a Reply

Your email address will not be published. Required fields are marked *